How to Replace the iPhone 14 Rear Camera
When photos come out soft, the lens rattles, or the Camera app opens to a black screen, the rear camera module is usually the culprit.
The iPhone 14 rear camera is one module with both lenses on it, held in by a bracket and three screws. Because the 14 opens from the back, you never have to touch the screen to replace it. Before you order anything, run the quick checks below. Some camera problems are not the camera at all.
Check these first
- Remove the case. Magnetic and metal cases are a common cause of shaking or buzzing lenses.
- Inspect the lens cover glass. A cracked or scratched cover causes haze and flare. A new camera module will not fix a damaged cover.
- Restart and update iOS. A frozen Camera app can be software.
- Test each lens. If the 1x lens is blurry but 0.5x is sharp (or the other way around), the module has a hardware fault.
If the image still will not focus, the lens jitters with the case off, or the camera stays black, it is time for a new module.
What you need
- iPhone 14 rear camera or iPhone 14 Plus rear camera
- P2 pentalobe, Y000 tri-point and Phillips #00 screwdrivers
- Suction handle, plastic picks, spudger and tweezers
- Hair dryer or heat gun, back glass adhesive, 90% or higher isopropyl alcohol
Step-by-step: iPhone 14 rear camera replacement
Remove the two pentalobe screws by the charging port. Heat the back glass edges, lift with a suction handle and slice the adhesive with a pick, staying shallow. Swing the back glass open from the left side. It is still attached by a cable, so do not pull it away.
Remove the two tri-point screws on the battery connector cover, lift the cover, disconnect the battery and bend the connector slightly away from the board.
Remove the tri-point screw on the charging coil connector cover, disconnect the coil and set the back glass aside.
Take out the three Phillips screws holding the camera assembly. Keep track of which screw came from which hole.
Pry both camera connectors straight up with a spudger. If another cable lies over them, lift it gently out of the way first instead of prying under it.
Pry up the top edge of the camera assembly and lift it out with tweezers or your fingers. Avoid touching the lenses.
Set the new module in, connect both cables, reconnect the battery and power on. Test 1x and 0.5x photos, tap to focus near and far, and record a short video while walking to check stabilization. Then power off and disconnect the battery. Our parts terms ask you to dry test before full installation.
Seat the module, refit the bracket and three screws, then reconnect the charging coil and the battery last. Refit both connector covers, clean the frame, apply fresh adhesive, hook the top clips in first and press the glass down. Reinstall the pentalobe screws.
Aftermarket Plus or Premium?
| Model | Aftermarket Plus | Premium |
|---|---|---|
| iPhone 14 | $59.99 | $89.99 |
| iPhone 14 Plus | $54.99 | $79.99 |
Aftermarket Plus restores normal focus and clear everyday photos. Premium uses higher grade components for more consistent focus and image quality closer to the original. If you take a lot of photos of kids, pets or anything that moves, Premium is worth the extra.
After the swap, iOS may list the camera as Unknown in Parts and Service History, because Apple only verifies its own parts. The camera still works. See what the Unknown Part message means.
Other models from iPhone XR to iPhone 16 Pro Max are in our camera parts collection.
Prefer a pro to handle it?
Send your iPhone to Strictli and our Strictli Certified technicians will replace the camera for you.
Start a mail-in repairFAQ
Why is my iPhone 14 camera shaking or making a buzzing sound?
Try it without a case first, since magnets can interfere with stabilization. If it still shakes, the stabilization in the camera module has failed and the module needs replacing.
Do I need to remove the screen to replace the iPhone 14 camera?
No. The iPhone 14 and 14 Plus open from the back, so the screen stays in place.
Will the new camera need calibration?
Apple's Repair Assistant calibrates genuine Apple parts only. A non-Apple module works without it, though iOS may label it Unknown.
Does this fix a cracked camera lens cover?
No. The cover glass is separate from the camera module. If only the cover is cracked, the module itself may be fine.
Prices and stock as of November 12, 2026. Repairs you perform are at your own risk; see our parts purchasing terms for warranty details.

